Lamp - Martin FiberSource QFX 150 User Manual

L
AMP
The FiberSource QFX 150 is designed for use with the Osram HQI-R 150 lamp. Do
not install any other type of lamp.
Warning! Disconnect the fixture from power and allow it to cool before
opening.
Important! Turn the lamp so that the arc is horizontal.
To inst all or posit ion the lamp
1 Remove the 4 lamp access
cover screws and pull off the
a c c e s s
indicated by the arrow on the
rear panel.
2 To remove the lamp, place a
hand under it and pull it out. Do
not lift by the ceramic base
alone. Squeeze the sides of the
lamp plug and pull it out.
3 To position the lamp, turn it so the wires,
where they exit the lamp base, point
towards the ground when the fixture is
installed . This puts the arc in its ideal
burning position.
4 To install a lamp, plug in the connector
and then place the reflector rim in the
slot. Gently press the lamp between the
springs until it snaps into place.
5 Remove and turn the diffusion filter 90°, if necessary, so the long sides of the
prisms align with the arc.
6 Check the power setting as described in the next section before replacing the
lamp access cover.
6
c o v e r, w h i c h i s

Lamp

Turn lamp so wires Align long edge of
point towards
ground and arc is
horizontal.
2
diffuser prisms
with arc.