Konica Minolta Di1610 User Manual page 130

6.10 When Incorrect Copies Are Produced
Symptom
The copy has dark specks or spots.
The copy has lines.
The image on the copy is not aligned
properly.
The printed page is curled.
Di1610/Di1610p
Possible Cause
The Original Glass surface is
dirty.
The Original Pad is dirty.
The original is highly
transparent.
The original is 2-sided.
Something is sticking to the
Original Glass (when the Auto
Document Feeder is used).
The Drum Cartridge has
reached the end of its service
life.
The original is not placed in the
correct position.
The original may not be
suitable for use in the Auto
Document Feeder.
The paper guides are not
pressed up against the paper
stack in the tray.
The paper has an excessive
curl.
The paper that was used curls
easily (as with recycled paper).
Action
Wipe the Original Glass clean
with a soft, dry cloth.
Wipe the Original Pad clean
with a soft cloth dampened with
neutral detergent.
Place a blank sheet of paper
over the original.
If a thin double-sided document
is being copied, the information
on the back side may be
reproduced in the copy. Press
the [ ] key and select a lighter
Ö
copy density.
Wipe the Original Glass clean
with a soft, dry cloth.
Contact your service
representative.
Place the original correctly on
the Original Glass against the
Original Scales.
Or, load it in the Auto
Document Feeder correctly
along the Document Guide
Plates.
Raise the Auto Document
Feeder and place the original
on the Original Glass correctly
against the Original Scales.
Slide the paper guides against
the edges of the paper stack.
Smooth out curls in the paper
and reload the paper stack in
the tray.
Remove the paper from the
paper tray, turn it over, and
then load it again.
Change the paper.
6
6-27