Utility Mode; Specifying The Machine Settings - Konica Minolta Di1610 User Manual

5
5.1

Utility Mode

There are four menus in the Utility mode.
No. Name
1 MACHINE SETTING
2 PAPER SOURCE
SETUP
3 USER MANAGEMENT
4 COPY SETTING
5.2

Specifying the Machine Settings

From the "MACHINE SETTING" menu, various settings for the machine's operating
environment can be specified. Refer to the following table for details on each
function.
No. Name
1 AUTO PANEL RESET
2 ENERGY SAVE
MODE
3 DENSITY (ADF)
4 DENSITY (BOOK)
5 PRINT DENSITY
6 LCD CONTRAST
7 LANGUAGE
5-2
Description
Used to specify settings for the machine's operating environment.
Used to specify the size and type of paper loaded in Tray1. In addition,
auto tray switching can be enabled for each tray.
Used to specify settings after the drum cartridge is replaced.
Used to specify the default settings for each copy function.
Description
Whether the Auto Panel Reset function is disable or the time (0.5 min,
1 min, 2 min, 3 min, 4 min, or 5 min) until the machine is reset after
finishing copying/printing or after performing the last operation can be
selected. If the Auto Panel Reset function is enabled, all functions are
automatically reset to their default settings.
• The factory default setting is 1 min.
If the machine performs no operations for a set length of time, it will
automatically enter the Energy Save mode. The length of time until the
machine enters Energy Save mode can be set between 1 min and
240 min (in 1 min increments).
• The factory default setting is 15 min.
The scanning density when using the Auto Document Feeder can be
adjusted.
Mode 1: For printing lighter copies of dark documents to avoid
darkening of copies.
Mode 2: For printing copies with same density as documents.
• The factory default setting is "Mode 1".
The density when scanning from the Original Glass can be adjusted.
Mode 1: For printing copies with same density as documents.
Mode 2: For printing lighter copies of dark documents to avoid
darkening of copies.
• The factory default setting is "Mode 1".
The copy/print density can be adjusted to one of six levels between –3
and +2. With the normal print density at 0, choose a smaller number for
a lighter print or choose a higher number for a darker print.
• The factory default setting is "0" (Normal).
The brightness of the display can be set to one of four levels between
–1 and +2.
• The factory default setting is "0" (Normal).
The display language can be selected.
• The factory default setting is "English".
5.1 Utility Mode
Di1610/Di1610p