Error Messages (Operator Call:) - Konica Minolta bizhub 40p User Manual

Error Messages (Operator Call:
This message...
CHECK LEVER
FACE UP TRAY
IS SELECTED
COVER OPEN
DUPLEX COVER
COVER OPEN
FINISHER COVER
COVER OPEN
REAR COVER
COVER OPEN
TOP COVER
HOLD JOB ERROR
UNABLE TO
STORE JOB
HOLD JOB ERROR
"OPTIONAL"
PRESS CANCEL
INCORRECT TRAY
MEMORY FULL
PRESS CANCEL
Status, Error, and Service Messages
)
means...
The face up lever is
raised when duplex
printing or sub tray
output is specified.
The duplex cover is
open.
The offset tray cover
is open.
The printer's rear
cover is open.
The printer's top
cover is open.
The specified print job
saved on the hard
disk is sent while the
hard disk is not
installed.
When printing a
stored job, the printer
configuration was
changed since the job
was stored.
The installed option
tray is an unap-
proved type.
The printer has
received more data
than can be pro-
cessed with its inter-
nal memory.
do this...
Pull the face up lever
down.
Close the duplex cover.
Close the offset tray
cover.
Close the rear cover.
Close the top cover.
Print jobs can be saved
only if a hard disk is
installed. If desired,
install a hard disk.
Change the printer con-
figuration to that when
the job was stored.
Turn off the power of the
printer, and then remove
the tray.
Press the Cancel key to
cancel the print job.
Decrease the amount of
data to be printed (for
example, by decreasing
the resolution), and then
try printing again.
If that doesn't solve the
problem, install an
optional memory mod-
ule.
185