Setting The System Date And Time - Lenovo ThinkServer User Manual

Menu item
Bootup Num-Lock
POST Error Pause
Boot Manager menu
This topic provides information about the Boot Manager menu in the Setup Utility program.
The Boot Manager menu lists all the bootable devices installed on your server system board and the items
listed vary depending on your server configuration and installed option devices. If you select a desired
device listed on this menu, the server will start from the device you select.
You can press F12 when turning on the server and select a temporary startup device directly from the boot
device selection window. See "Selecting a startup device" on page 66.
Exit menu
This topic provides information about the Exit menu in the Setup Utility program.
After you finish viewing or changing settings in the Setup Utility program, you can choose one desired action
from the Exit menu to save changes, discard changes, load default values, and exit the program. The
following table lists each item on the Exit menu with descriptions. Press Enter to select the item and then
select Yes when prompted to confirm the action. For information about exiting the Setup Utility program,
see "Exiting the Setup Utility program" on page 67.
Exit menu items
Save Changes and Exit
Discard Changes and Exit
Save Changes
Discard Changes
Load Default Values
Save as User Default Values
Load User Default Values

Setting the system date and time

This topic provides instructions on how to set the system date and time in the Setup Utility program.
To set the system date and time in the Setup Utility program, do the following:
1. Start the Setup Utility program. See "Starting the Setup Utility program" on page 55.
2. On the Main menu, select System Date or System Time.
3. Use the Tab key to switch between data elements and type the numbers from the keyboard to set the
system date and time.
4. Press F10 to save settings and exit the Setup Utility program.
64
ThinkServer User Guide
• On
• Off
• Disabled
• Enabled
Item
Selections
Save your settings and exit the Setup Utility program.
Discard your settings and exit the Setup Utility program.
Save your settings.
Discard your settings and load previous values.
Return to the optimized default settings.
Save the changes so far as user default values.
Restore the user default values for all the items.
Comments
Turn the Num-Lock key on or off.
Enable or disable the POST error
pause feature. When this feature
is set to Enabled, the system will
stop on the POST screen if any error
occurs during the POST.
Comments