Lenovo ThinkServer User Manual page 125

8. Connect the other end of the signal cable to the Intelligent Diagnostics Module connector on the
system board. See "System board components" on page 42. Then, properly route the signal cable
of the Intelligent Diagnostics Module. You might need to secure the signal cable with cable clips or
ties in the chassis.
Figure 52. Cable routing
9. Reinstall the front system fan(s). See "Replacing the front system fan" on page 149.
10. Reinstall the front bezel. See "Removing and reinstalling the front bezel" on page 87.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation, go to "Completing the parts replacement" on page 162.
Removing the Intelligent Diagnostics Module
Attention: Do not open your server or attempt any repair before reading and understanding the "Safety information"
on page iii and "Guidelines" on page 83.
This topic provides instructions on how to remove the Intelligent Diagnostics Module.
This topic applies only to server models that come with the Intelligent Diagnostics Module.
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
1. Depending on the model, your server might look slightly different from the illustration in this topic.
2. If you remove the Intelligent Diagnostics Module, the server will lose the diagnostic LEDs on the IDM
panel.
.
Chapter 6 Installing, removing, or replacing hardware
113