Table of Contents
Advertisement
NTI XTENDEX 300 Foot HDMI and IR Extender
INSTALLATION
Installing The Remote Unit
1.
Position the Remote Unit such that the CATx cable, the monitor cable(s), and device cables can each reach the
Remote Unit without putting strain on the cables.
2. Connect a HDMI-xx-MM (or DVI-HDMI-xx-MM cable depending upon what connector your display will accept) to the
female HDMI video connector labeled "HDMI Out" on the Remote Unit.
3.
The keyboard and mouse cables can be plugged into the USB ports.
4.
If your monitor is a touchscreen monitor with USB interface, and if you have an XTENDEX model with extra USB port
(as seen below), the USB cable from the monitor can be connected to one of the USB ports. This extra port can
also be used to connect a Whiteboard or CAC reader.
Note: Only models with the extra USB port present (models ST-C6USBHU-300 or ST-C6USBHU-IR-300) will support the
use of a touchscreen monitor, CAC reader, or Whiteboard.
Figure 1- Connect the extended components to the Remote Unit
5
Advertisement
Table of Contents
