Nfc/Osaifu-Keitai Settings; Android Beam - Docomo F-02E Arrows X Instruction Manual

Using "Osaifu-Keitai service"
1
From the Application menu, [Osaifu-Keitai]
If the initial setting has not yet made, the initial setting
screen appears. Follow the onscreen instructions to set.
2
Select a service
3
Set up the service
Make the required settings from the service site or
application.
4
Hold mark over a card reader
mark
✔INFORMATION
When reading/writing data, you need not activate Osaifu-
Keitai app.
Powering on the terminal is not necessary, but attaching the
battery pack is required for use. If the terminal remains
powered off for a long time or battery is low, the function may
not available even if the battery pack is attached,
IC card reader
Using "
(Kazashite-Link compatible service)"
1
From the Home screen,
WIRELESS & NETWORKS, [More...] [NFC/
Osaifu-Keitai Settings]
If [Lock NFC/Osaifu-Keitai] is marked, unmark the
checkbox.
2
Mark [Reader/Writer, P2P]
3
Hold mark over a device equipped an NFC
module, a smart poster, etc.
❖

Android Beam

Transfer data between the terminal and a Reader/Writer, P2P
equipped terminal.
To use Android Beam, set to allow data transfer beforehand.
When "Lock NFC/Osaifu-Keitai" is activated, Android Beam
cannot be used.
Android Beam cannot be used on some applications.
Available data varies by applications.
Data transfer is not guaranteed for all Reader/Writer, P2P
equipped terminals.
1
From the Home screen,
WIRELESS & NETWORKS, [More...] [NFC/
Osaifu-Keitai Settings]
If [Lock NFC/Osaifu-Keitai] is marked, unmark the
checkbox.
2
Mark [Reader/Writer, P2P]
132
[Settings] In
[Settings] In
Applications