Advertisement
8
Setting Up and Connecting
Note: You must install the software before connecting the
analyzer to the host machine for the first time.
To set up the analyzer:
1. Connect the analyzer to a 100V–240V, 50Hz–60Hz,
power outlet and turn on the Power switch.
At power on, the analyzer will go through initialization
as shown on the LCD display.
2. Connect the USB cable between the SierraNet M408
USB port and a USB port on the host machine. The
host machine operating system detects the analyzer
and loads the driver files. (See Section 10 for how to
connect via Ethernet.)
9
Starting the Application
To launch the software, select Start > All Programs > LeCroy > Net Protocol Suite.
Select Menu > Setup > Device Management (see screen capture on the right) to display
the Device Management dialog. Click Refresh Device List (see screen captures below) to
display all the devices on the network. Select a device and click Connect.
To start using the protocol analyzer and software, see the Protocol Analyzer chapter of the SierraNet M408 User Manual.
3. Connect your devices using SFP+ optics and a fiber
cable suitable for your setup.
4. Connect the 10 GigE or Fibre Channel devices to port
pairs P1/P2, P3/P4, P5/P6 and/or P7/P8 and connect
40 GigE devices to port pair P9/P10.
For an illustration of the cabling, see the Introduction
chapter of the SierraNet M408 User Manual.
Advertisement
