Table of Contents
Advertisement
Operating instructions 82132/3XXX - Combi B 30
9.2.5
Code status query (P6)
The status of any code (active, blocked or inactive resp. deleted) can be requested in this query program. Neither the codes nor
their statuses are changed by this operation. The statuses of any number of IDs can be requested successively. Different code
statuses are given in Table 13.
Description
1. Press
and enter the valid master code
(00 = ID, X = valid 6-digit combination for the master)
2. Press
and
Enter all the ID(s) to be requested
3.
One code status message is generated for each ID according to
Quit the query mode by pressing
4.
Alternatively, wait for 30 seconds
Table 12: Requesting code status
Code status message
(active) 1x
(active but blocked) 1x
(deleted/inactive)
Table 13: Code status messages
9.3
Programming opening delay and opening standby time (P2)
Opening delay (OD) is the time period which has to elapse before the lock can be opened. The opening standby time (OST)
denotes the time window during which the lock can be opened as soon as the OD has elapsed. This program is used to set or
delete the OD (01 to 99 minutes) and the OST (01 to 19 minutes). The set times apply to all users and for the master but not for
the courier.
9.3.1
Activating opening delay and opening standby time (P2)
To program opening delay (OD) and opening standby time (OST) proceed as follows:
Description
1. Press
and enter the valid master code
(00 = ID, X = valid 6-digit combination for the master)
2. Press
and
3. Enter the opening delay
(XX = 01 to 99, YY= 01 to 19, specifications in minutes respectively)
Table 14: Programming opening delay and opening standby time
If the Incorrect code signal is displayed after step 3, the specified times are outside of the maximum permitted range.
The Incorrect code signal is also displayed if 00 is specified either only for the OD or for the OST. Both inputs are not
permitted.
9.3.2
Deactivating opening delay and opening standby time (P2)
To deactivate opening delay (OD) and opening standby time (OST), proceed as described in chapter 9.3.1; while doing so,
enter "00" for the 2-digit OD as well as for the 2-digit OST respectively. After that all operators can open the lock without delay.
successively and
.
1x
1x
1x
1x
1x
and the opening standby time
and
correspondingly
and
and
2x 3x 3x
2x
2x 3x 3x
3x 3x
3x
3x
2x
3x
3x
2x
3x
3x
2x
2x
3x
3x
Version 2013-08-10
Page 37 of 48
Advertisement
Table of Contents
