Important Notes - Kaba Combi B 30 Operating Instructions Manual

1

Important notes

Before the start-up of the lock read these operating instructions carefully and observe the following notes:
The enclosed inspection key allows full access to the lock and its configurations even in case of code loss.
Thus, it is at the highest hierarchy level of the lock. Therefore, it must be stored in a safe place, but not in the
secure storage unit.
For security reasons programming and battery replacement should always be performed and then tested with the secure
storage unit open.
Every correct key stroke recognized by the lock is confirmed by an acoustic signal.
You have max. 10 sec. for each individual key stroke. If no key is pressed during these 10 seconds, the electronics shuts
down automatically. Uncompleted operations must be restarted after that. The only exceptions to this are the code status
query and the programming mode with 30 seconds response time until automatic shutdown.
Code inputs resp. all further functions (e.g. programming operations) can be cancelled until the last key stroke by pressing
the key twice.
Do not use for your code personal or similar known data which are easy to find out.
If the set code(s) is(are) not available, the lock can be opened or reset using the enclosed inspection key.
The lock is designed for use in the temperature range from +10° C to +50° C and with humidity of 30% to 80% (non-
condensing).
The lock must never be greased with or contact other lubricants or aggressive liquids, it must be cleaned only with a moist
cloth only (no aggressive cleaning agents).
Never open the lock housing. Dismount the fitting only for battery replacement and perform it strictly according to the
specifications of these operating instructions. Avoid touching electronic components. Otherwise, you endanger the functions
of the lock and loose the right for the warranty claims.
During start-up the serial number of the input unit is saved in the audit memory of the lock. Replacement of the input unit is
also registered by means of an entry in the audit memory of the lock.
For every description of operation or programming processes hereafter it is assumed that the lock and the input unit are in
the basic state. Basic state means that the lock is closed (the bolt lock is extended) and the lock electronics is switched off.
If you are not sure, whether the lock is closed, check if the rotary knob can be turned counterclockwise. To ensure that the
lock is not in a running programming process, you can press the
Upon delivery the lock is set by Kaba Mauer GmbH to the assembler coder "1". For security reasons activate the
master code with your individual code immediately in order to deactivate the assembler code. The assembler code
is meant only for lock mounting, it is not suitable for further permanent use.
Furthermore, the lock has the option for partial or full start-up by the safe manufacturer or distributor:
For a partial start-up basic configurations are loaded to the lock without activation of the master code. So, the lock
still opens with "1". All configurations performed previously using software are immediately valid only after
activation of the master code (start-up according to 8.2).
For full start-up the lock has already been provided with a master code and further settings if necessary.
In both cases the set basic configuration is communicated separately by the safe manufacturer or distributor. If a
full start-up has been performed and, thus, a master code preset as delivery code, the safe manufacturer or
distributor can save it additionally in the following hatched text box.
All pre-configured codes have to be changed by the end user immediately after start-up.
The master code set by the distributor resp. safe manufacturer (delivery code):
0 0 _ _ _ _ _ _ _
Note for the end user:
Change all delivery codes immediately!
If further codes have been pre-assigned,
see separate information of the
safe distributor resp. manufacturer.
Version 2013-08-10
Page 28 of 48
Operating instructions 82132/3xxx CB 30
key twice to cancel it.
_
Stamp of the safe manufacturer/distributor
_