Table of Contents
Advertisement
Operating instructions 82132/3XXX - Combi B 30
Description
1. Open the lock using the key (see chapter 11.1)
2. Press
and
3. Press
and
4. Close the lock again by means of the key (11.2) and mount the rotary handle (11.1)
Table 28: Resetting the lock
This procedure can be canceled any time by pressing
input for 30 seconds or if the lock is locked using the key before step 3 (see chapter 11.2).
11.5
Reconfiguration of the lock after opening by means of the key using software
For further details on the procedure refer to the operating instructions for the PC software.
After opening the lock using the key according to 11.1 and connecting it to the PC software a complete reconfiguration of
the lock is possible, namely without knowing or changing the master code. Only an audit entry is performed.
12
Further special functions
12.1
Connection to the PC software
The lock has an additional mini-USB interface on the input unit. The lock can be programmed via this interface using the PC
software available as an accessory.
The following functions are available when using the additional PC software:
a)
Reading out audit
b)
Programming the lock settings using software
For further details on this refer to the operating instructions of the PC software.
12.2
Additional functions via the signal input
The lock has an option which allows implementing one of the additional functions via the signal input according to 10.8. The
assignment of the signal inputs is described in the installation manual of the lock. The functions can only be activated with the
optional PC software. The operating behaviour of the lock with different input signals active is described in 10.810.8.
12.3
Additional functions via the signal outputs
The lock has 2 signal outputs: Details on assignment of the outputs are given in the installation manual. The following outputs
are available:
a)
Silent alarm. For details on programming refer to chapter 9.5, on operation refer to chapter 10.4,
b)
Microswitch for bolt monitoring, no additional programming possible.
13
Power supply
Two batteries of type AAA are available in the input unit for power supply of the lock. It is highly recommended to replace them
every 2 years (see chapter 0), irrespectively of how often the lock has been used.
twice. Alternatively, the modification is canceled if there is no
2x 3x
3x
2x
2x 3x
3x
Version 2013-08-10
Page 45 of 48
Advertisement
Table of Contents
