Konica Minolta bizhub 750 Copy Manual page 457

12
9
Check the distances (b)
from the print position of
the test pattern to the
edge of the paper.
10
If the desire print results are not achieved, change the adjustment
value.
– To increase distance (b), touch [+].
– To reduce distance (b), touch [–].
– Each time [+] or [–] is touched, the value is increased or decreased
by one increment.
11
Repeat steps 6 through 10 until the desired print results are achieved.
12
Touch [OK].
– To cancel changes to the settings, touch [Cancel].
The print position is adjusted.
Note
Enter the value by mm using the keypad. Refer to the conversion rate be-
low. 1 in. = 25.4 mm
12-44
b
bizhub 750/600
Utility