Finisher - Konica Minolta bizhub 750 Copy Manual

5

Finisher

Symptom
The finisher cannot be
used.
The pages cannot be
stapled.
The staple is incorrectly
positioned by 90 de-
grees.
The pages that were fed
out were not uniformly
loaded and the punched
holes or staples are in-
correctly positioned.
Even though a Punch
setting was selected,
holes are not punched.
(when PK-505/ZU-602 is
installed on FS-504/FS-
602)
If any message other than those listed above appears, perform the operation
described in the message.
If the problem is not corrected after the described operation is performed,
contact your technical representative.
5-14
Possible Cause
Is there a paper misfeed in
the finisher?
Is the finisher door fully
closed?
Have the staples run out?
Are the staples positioned as
specified?
Is the paper curled?
Is there a gap between the
lateral guides in the paper
tray and the side of the pa-
per?
Did the message "Remove
Punch Scraps." appear?
Troubleshooting
Remedy
If there is a paper misfeed, clear it.
Securely close the finisher door.
Replace the staple cartridge. (See
p. 9-7.)
Select the desired position for the
staples. (See p. 3-59.)
Remove the paper from the paper
tray, turn it over, and then load it
again.
Slide the lateral guides in the paper
tray against the side of the paper so
that there is no gap.
Empty the punch dust box
bizhub 750/600