Muting The Devices - Sennheiser Tourguide System 2020 Instruction Manual

Tourguide2020_516509_0909_Sp6.book Seite 39 Montag, 22. März 2010 1:12 13
¿
CH 03
LINE
MIC
¹

Muting the devices

Muting the bodypack transmitter
Slide the MUTE
The red LED
»
nently. The
any deflection. The bodypack transmitter's micro-
phone input is muted.
Note:
The muting function (MUTE) mutes the microphone
» but not the line input ¿. This function
input
enables a pre-recorded track to be played through
the line input without being disturbed by the tour
guide's microphone. When the track has finished,
the guide can un-mute the microphone and con-
tinue talking.
To deactivate the muting function:
Slide the MUTE
The red LED
level display
cate the current levels.
Muting the radio microphone
Turn the protective cap
¹
switch becomes accessible.
²
Slide the MUTE
arrow.
"MUTE" appears on the display of the radio micro-
phone. After 5 minutes,
display (see "Display of the energy saving mode"
on page 16).
To deactivate the muting function:
Slide the MUTE
the audio signal again.
Using the components
·
switch to the left, to "MUTE".
LOW BATT/MUTE ¶
lights up perma-
MIC level display no longer shows
·
switch back to the right.
LOW BATT/MUTE ¶
goes off. The
and the LINE level display
²
so that the
¹
switch in the direction of the
"CH OFF" appears on the
¹
switch back in order to transmit
MIC
indi-
MUTE
39