Sennheiser Tourguide System 2020 Instruction Manual page 105

Tourguide2020_516509_0909_Sp6.book Seite 37 Montag, 22. März 2010 1:12 13
·
6
º
¾
´ µ
Setting the channel on the receiver
In order for the receiver to receive the signal from
the bodypack transmitter or radio microphone, it has
to be set to the same channel.
To manually set the receiver channel:
Press
• the channel selection button
HDE 2020 D or
• the channel selection button
EK 2020 D.
The channel changes. The selected channel is
shown on the channel display
If the bodypack transmitter or radio microphone
is transmitting on this channel, the RF signal
indication indicates the field strength of the
received RF signal.
Setting the receiver channel(s) using the channel
copy function
The channel copy function lets you simultaneously set
a maximum of 19 receivers in the charging case to the
same channel. This is achieved by copying the current
channel of the receiver placed into the charging com-
partment with channel copy function (master)
all other receivers in the charging case.
Place all receivers which are to be set to the same
channel into the charging compartments for
receivers (slaves, light blue in the diagram) ´.
Switch on the receiver whose channel you want to
copy.
Place this receiver into the charging compartment
with channel copy function (master) µ.
COPY AVAILABLE º
The LED
as the channel copy function is available.
Press the COPY button
function.
The displays of all receivers which are successfully
set to the same channel light up.
Using the components
´
/ of the
·
/ of the
.
lights up green as long
¾
to start the channel copy
µ
to
37