Adjusting Toe-In - Kubota RTV500 Operator's Manual

Table of Contents

Advertisement

(1) Battery
1. To slow charge the battery, connect the battery
positive terminal to the charger positive terminal and
the negative to the negative, then recharge in the
standard fashion.
2. A boost charge is only for emergencies. It will partially
charge the battery at a high rate and in a short time.
When using a boost-charged battery, it is necessary to
recharge the battery as early as possible.
Failure to do this will shorten the battery's service life.
3. When exchanging an old battery for a new one, use
battery of equal specification shown in table below.
Capacity
Battery
Volts (V)
at 20 hrs
TYPE
426 MF
12
C Direction for Storage
1. When storing the vehicle for a long period, remove the
battery from vehicle, adjust the electrolyte to the
proper level (refillable type only) and store in a dry
place out of direct sunlight.
2. The battery self-discharges while it is stored.
Recharge it once every 3 months in hot seasons and
once every 6 months in cold seasons.
Reserve
Cold
Capacity
Cranking
(A.H.)
(min)
Amps
32
55
450
BAdjusting Toe-in
Proper toe-in
1. Park vehicle on a flat place.
2. Turn steering wheel so front wheels are in the straight
ahead position.
3. Lock the park brake and stop the engine.
4. Measure distance between tire beads at front of tire, at
hub height.
5. Measure distance between tire beads at rear of tire, at
hub height.
6. Front distance should be shorter than rear distance. If
not, adjust tie rod length.
(A) Wheel - to - wheel distance at rear
(B) Wheel - to - wheel distance at front
(C) "FRONT"
PERIODIC SERVICE
0 to 20 mm (0 to 0.79 in.)
55

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents