Post-Filter Replacement; Recharging The Bladder Tank - SpectraPure 4-Stage Compact DWS-CLS-3 Operation Manual

Ro drinking water system for coffee lovers

Hide thumbs

Table Of Contents

Table of Contents

SpectraPure

Maintenance Regime: At least once in 12 months or whenever odor or bad taste occurs.

Materials Needed:

Replacement Carbon Post-Flter.

Procedure:

1. Turn off feed supply valve and tank shut-off valve.

2. Remove the filter housing from its cap by unscrewing it clockwise as viewed from the top or side.

3. Discard old filter.

4. Thoroughly wash out the housing with hot soapy water to which a few teaspoons of household bleach have been

added, and rinse well with clean hot water.

5. Install the new post-filter.

6. Turn on both tank shut-off valve and feed supply valve. (Check for leaks)

Re-Mineralization Cartridge Replacement

Maintenance Regime: At least once in 12 months or whenever more than 50% of the minerals are exhausted.

Materials Needed:

Replacement StablePure

Procedure:

1. Turn off feed supply valve and tank shut-off valve.

2. Remove the filter housing from its cap by unscrewing it clockwise as viewed from the top or side.

3. Discard old cartridge.

4. Thoroughly wash out the housing with hot soapy water to which a few teaspoons of household bleach have been

added, and rinse well with clean hot water.

5. Install the new cartridge.

6. Turn on both tank shut-off valve and feed supply valve. (Check for leaks)

If the storage capacity of the tank is diminished significantly it is likely that the tank has lost its air charge. Recharging the

bladder tank will restore its capacity.

1. Put the dispenser faucet in the "open" position (lever in up position). Leave the faucet in the open position till the

procedure is completed.

2. Drain as much water as possible from the tank.

3. Hook up an air pump to the "Schrader" (tire) valve on the pressure tank and start pumping air into the tank.

4. Expel all the water from the tank.

5. Continue pumping air into the tank until the pressure reads 6 psi.

6. This completes the procedure.

Note: Should this procedure fail to restore the capacity of the tank, it is very likely that the bladder in the tank is ruptured

and the tank needs replacement.