Table of Contents
Advertisement
CABLE AND ELECTRIC APPLIANCE SYSTEM
Mount
Mount as the reserves steps as
1.Mount:
Brush spring
Brush
Note
When mounting brush the brush wire should round
over the projection outside of brush spring clip.
When mounting brush, make the brush terminal
touch slightly the projection of brush spring clip side.
2. Mount
Armature
Note
When mounting the armature, press the brush with
small screwdriver to avoid damaging it.
3. Install
O-ring
Note
Replace a new one.
4. Install
Magnetic yoke
Note
Aimed the marks to the rear brocket s matching
mark and then install.
5. Install
Washer
Front brocket
Note
Aimed the boss of washer to the groove of front
brocket, and then install.
Make the marks of gear and front and rear brock-
ets matching.
Install
Starting motor
Starting motor wire
177
remove
Bolt
0.5Kgf.m(5N.m)
Bolt
0.7Kgf.m(7N.m)
Hide quick links:
Advertisement
Table of Contents
