Raytheon STD 21 GPS Operation Manual page 76

From all possible settings, only one setting may be selected in the PU Mounting Menu.
A selected item is designated with a " √ " in the rectangle.
Procedure to leave "GPS Setup" with a changed configuration.
If a PU Mounting position change has been made, operate the soft key "Set" and the dis-
play "GPS Setup" is shown again with additional menu options to acknowledge the
change or to discard the setting.
Figure 57: Display "GPS Setup" after changes have been made in one of the submenus
To store the change, select "Store settings and restart system" with the soft key "Select"
and operate "Set". The STD 21 GPS will restart and, after the initialization and acquisi-
tion procedure, the display "GPS Pos." (Basic Display) is shown (see Figure 8).
Procedure to leave "GPS Setup" without a changed configuration.
Select "Exit" without performing a change in the submenu "PU Mounting"
(see Figure 56), the display "GPS Setup" (without additional menu) is shown
(see Figure 50) .
or
Select "Discard Changes" with the soft key "Select" and operate "Set", then the
display "GPS Setup" is shown again (see Figure 50).
3717/110--850.DOC020002
Satellite Compass
GPS Setup
GPS
Pos.
Software Versions
Serial Port #3
Serial Port #4
Sat.
PU Mounting
Status
AU Alignment
Discard Changes
Store settings
and restart system
Select
STD 21 GPS
Dim
up
Dim
down
Set
68
Edition: Feb. 05, 2007