Submenu "Pu Mounting - Raytheon STD 21 GPS Operation Manual

3.5.4

Submenu "PU Mounting"

After selecting submenu "PU Mounting", the following display is shown:
(Note: from "GPS Setup", press and hold "Set" for 5--10 seconds to enter this submenu)
Figure 56: Submenu "PU Mounting"
It is absolutely necessary to set this position immediatedly after installation or changes
to the PU Mounting position. It defines the position of the accelerometers which are built
into the processor unit, see also section 3.3.
Ceiling bow
Ceiling port
Ceiling aft
Ceiling starboard
Floor bow
Floor port
Floor aft
Floor starboard
Edition: Feb. 05, 2007
Satellite Compass
STD 21 GPS
PU Mounting
Ceiling bow
Ceiling port
Ceiling aft
Ceiling starboard
Floor bow
Floor port
Floor aft
Floor starboard
Select
Exit
= Processor Unit is installed on the ceiling and the cable
inlets show into direction bow.
= Processor Unit is installed on the ceiling and the cable
inlets show into direction port.
= Processor Unit is installed on the ceiling and the cable
inlets show into direction aft.
= Processor Unit is installed on the ceiling and the cable
inlets show into direction starboard.
= Processor Unit is installed on the floor and the cable inlets
show into direction bow.
= Processor Unit is installed on the floor and the cable inlets
show into direction port.
= Processor Unit is installed on the floor and the cable inlets
show into direction aft.
= Processor Unit is installed on the floor and the cable inlets
show into direction starboard.
Dim
up
Dim
down
Set
67
STD 21 GPS
3717/110--850.DOC020002