Raytheon STD 21 GPS Operation Manual page 37

-- Push the counterpart of the earthing insert as far as the end of the cable
shield.
-- Push the earthing insert cone below the shielding against the counterpart.
Observe a shared even distribution of the shielding via the cone (see Figure 25).
Figure 25 Making the cable entry
-- Insert the earthing insert, the seal, and the washer into the cable gland, place
the counter nut on top and hand-tighten.
-- Strip the cable cores to a length of approx. 15mm, twist slightly and clamp on the
cable end sleeves. Connect the cable wires in the respective housing.
Hand-tighten the terminal screws concerned.
-- Check the connection is firm by pulling lightly.
Edition: Feb. 05, 2007
Satellite Compass
Wall and DIN Socket
Shielding
STD 21 GPS
Earthing insert
-- cone
-- counterpart
Seal
+ strain relief
Washer
Counter nut
29
STD 21 GPS
3717/110--850.DOC020002