Setting The Dip--Switches For The Std 21 Gps At The Processor Unit - Raytheon STD 21 GPS Operation Manual

3.3.6 Setting the DIP- -switches for the STD 21 GPS at the Processor Unit
(CAN- -Bus addresses and operating modes)
Figure 42:
Devices which communicate on the CAN bus need a unique address.
This address must be set with the DIP switch "Config" (see Figure 42).
Switches 1 and 2 are responsible for this address.
Set the switches according to the table below.
Edition: May 29, 2009
Satellite Compass
DIP switch
"CONFIG"
DIP switch to adjust the device address for the CAN bus
and to adjust operating modes
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
ON
1 2 3 4 5
= Switch is insignificant for this function (continued on next page)
STD 21 GPS
6 7 8
6 7 8
6 7 8
6 7 8
49
STD 21 GPS
Switch 1 and 2 into
the OFF position:
CAN Address 10
Company default!
Switch 1 into the ON
position and switch 2
into the OFF position:
CAN Address 11
Switch 1 into the
OFF position and
switch 2 into the ON
position:
CAN Address 12
Switch 1 and 2 into
the ON position:
CAN Address 13
3717/110--850.DOC020002