Setting The Device Address - Raytheon STD 21 GPS Operation Manual

3.4.3

Setting the device address

Use the two hexadecimal switches to set the device address for the Operator Unit. The
device address is set by the manufacturer to 01 decimal.
Changing this setting is only necessary if another Operator Unit is installed.
The table below shows the address agreements depending on the device type within a
navigation system.
If the Operator Unit is operated on an RS422 interface (jumper setting), the device ad-
dress has no significance.
3717/110--850.DOC020002
Device(s)
Operator Units
GPS compass
Sensors
(Gyro Compass)
Distribution Units
Repeaters
Each device address can be allocated within a CAN bus
system only once!
Satellite Compass
STD 21 GPS
CAN- -Bus- -Ad-
dress, decimal
01 to 09
10 to 13
14 to 19
20 to 29
30 to 63
52
CAN- -Bus- -Ad-
dress,
hexadecimal
01 to 09
0A to 0D
0E to 13
14 to 1C
1E to 3F
Edition: Jan. 16, 2009