Connecting The Antenna Cable To The Processor Unit - Raytheon STD 21 GPS Operation Manual

3.3.2

Connecting the antenna cable to the Processor Unit

Figure 37:
The cable has to be stripped off and laid according to section 3.1.1.
The cable cores have to be connected into the terminals according to appended
drawings or according to the table below.
Edition: Feb. 05, 2007
Satellite Compass
STD 21 GPS
The cable between the Antenna Unit and the
Processor Unit is part of delivery with the part no. NB60--144.
This cable should be lengthened to a practicable length.
The antenna cable should be fastened with tie--wraps if it will
not be internal to the mast. The cable must be routed to the
Processor Unit and affixed by appropriate elements.
The antenna cable must be securely fixed. Ensure there is
enough slack in the cable where it attaches to the Processor
Unit so that the cable connection is not stressed.
Except the Antenna Unit no additional connections
should be made at this terminal board!
Terminal board A1
Cable connection of antenna cable at the Processor Unit
43
STD 21 GPS
3717/110--850.DOC020002