General Remarks For Establishing Cable Connections - Raytheon STD 21 GPS Operation Manual

3.1.1

General remarks for establishing cable connections

In order to ensure that the system operates correctly, it is essential that you adhere to
the following procedures for establishing cable connections.
-- Strip approx. 180mm off the cable.
Do not damage the shielding layer.
-- Strip off the shielding as shown in Figure 24.
Figure 24 How to strip the connection cable
-- Screw the cable gland out from the respective housing and push the screw
connection components over the cable.
It is absolutely essential that the sequence (as shown in Figure 25) is adhered to.
-- Check the cone and counterpart on the earthing insert for corrosion and,
if necessary, remove corrosion.
3717/110--850.DOC020002
Satellite Compass
STD 21 GPS
Caution
When establishing cable connections ensure that the cables
are disconnected from the power supply.
It is essential to ensure that all cables are disconnected from
the power supply, if necessary measure the voltage beforehand
and/or disconnect the relevant distributor.
approx.
15mm
approx. 180mm
28
Edition: Feb. 05, 2007