Electrical System - Fuse Box; Electrical System - Power Distribution And Fuse Box Layout - ILMOR MV-10 Owner's Manual & Installation Manual

Electrical System – Fuse Box
Fuse box Cover Removal
The Fuse box and ECU cover is
constructed of carbon fiber and is
mounted to the engine by three
rubber grommets, like the fuel rail
covers. To remove the front cover,
begin by grasping the back edge of
the cover as shown.
steady pressure pull directly forward.
This will release the grommets from
the engine-side mounts. Any twisting
motion will increase the chance of
damage. To re-install, apply soapy
water to each of the three grommets,
align grommets to the mounts and
press on.

Electrical System - Power Distribution and fuse box layout

20A
PWR
A
With light yet
H
40A 15A 15A
STRT IGN FUEL
B C D
ASD FUL STRT
RLY RLY RLY
E F G
Owner's Manual &
Installation Instructions
Revision 6e
Fig. 18
FUSES
A.Power 20amps
B.Starter 40amps
C.Ignition 15amps
D.FuelPump 15amps
RELAYS
E.ASD
F.FuelPump
G.Starter
CIRCUIT BREAKER
H.CB 50amps
Fig. 19
Page 27