Maintenance - 25 Hour Service - ILMOR MV-10 Owner's Manual & Installation Manual

Maintenance - 25 Hour Service

At the end of the 25 hour break-in period the MV10 engines must be serviced before
the break in period can be considered complete. The following list of maintenance
must be performed.
Change engine oil and filter.
Change fuel / water filter.
Check drive shaft and engine alignment.
Check coolant level and top off if needed.
Check power steering fluid level and top off if needed.
Check throttle and shift cables for proper end stop adjustment.
Check all hoses and lines for leaks or damage. Repair as necessary.
Check the complete exhaust system for damage or leaks. Check all hose clamps
for tightness. Check that the header bolts are tight.
NOTE: Do not over tighten header bolts, torque to 25 lb/ft torque.
Check the battery condition. Check all battery connections are tight.
Check motor mounts and mounting bolts.
Check starter, bell-housing bolts, transmission bolts are tight.
Maintenance – Engine Life
After 245 hours of service or 5 years, it is recommended that all mv-10 engines be
refurbished.
Owner's Manual &
Installation Instructions
Revision 6e
Page 44