ILMOR MV-10 Owner's Manual & Installation Manual page 8

Owner's Manual &
Installation Instructions
Revision 6e
Mounting the Engine cont'd
Staggered Front (PE00562, PE00563)
Stringer mounting hole spacing: From crankshaft, 6.9" (low side) & 14.9" (high side).
Typically used on
twin engine v-hull
applications with
space limitations
requiring one engine
mounted slightly ahead
of the other (staggered).
A drive-extension kit must be
used with the forward engine,
typically referred to a as a "driveline" setup.
Note: driveline engine packages are supplied without headers.
Staggered Rear (PE00566)
Stringer mounting hole spacing: From crankshaft, 6.9" (low side) & 14.9" (high side).
This plate is reversible, use the same plate for both sides.
Side-by-side Front (PE00528, PE00529)
Stringer mounting hole spacing: From Crankshaft, 13.5" (low side) & 12.5" (high side).
Page 8