ILMOR MV-10 Owner's Manual & Installation Manual page 17

Owner's Manual &
Installation Instructions
Revision 6e
Fuel Injection System - 550 and older 625 models cont'd
(without return to tank fuel)
FUEL FILTER/ WATER SEPARATOR ADAPTER
A – Fuel inlet from tank. Use right-hand or left-
hand as necessary, following arrows cast into filter
B
base.
B – Fuel outlet to fuel pump. Again use right-hand
A
or left-hand as necessary, following arrows marked
on adapter.
Fig. 9
FUEL PUMP
B
A
A – Positive connection terminal. Connect
green/white stripe wire with 3mm ring terminal.
B – Negative (ground) connection terminal.
Connect tan wire with 4mm ring terminal.
*Posts are labeled with a (+) and (-)*
Fig. 10
FUEL PRESSURE REGULATOR / HIGH PRESSURE FILTER
C
A – Excess fuel return to
water/fuel separator.
A C
B – Fuel inlet from cooler.
B
C – Outlet to fuel rails
(quick-release fitting).
Fig. 11
Page 17