Fuse Box - ILMOR MV8 570 Owner's Manual

SECTION 2 ILMOR HIGH-PERFORMANCE OWNER'S MANUAL
2-4

Fuse Box

In addition to circuit breakers in the boat that may impact the engine
functionality or ancillary equipment and electronics that borrow power
from the engine, the engine is also equipped with a fuse box that adds
control over various electronic func tions of the engine.
MV10 Fuse Box
The fuse box cover is mounted to the engine by three rubber grommets.
To remove the front cover, begin by grasping the back edge of the cover
as shown. With light, yet steady pressure, pull directly forward. This will
release the grommets from the engine-side mounts. Any twisting motion
will increase the chance of damage. To reinstall, apply a non-petroleum
based lubricant to each of the three grommets. Align grommets to the
mounts and press on.
MV10 Power Distribution and Fuse Box Layout:
1) Ignition Power
2) ASD1 Power
3) ASD2 Power
4) Fuel Pump Power
5) Starter Solenoid
6) Dash Gauges
7) ECM "Clean" Power
8) Dash Low Currents
9) ASD Relay Control (Diode)
Ilmor High-Performance Marine, LLC
© 7/2013, Version 1.0