Preparing The Audio Input System; Using The Supplied Microphone; Using An External Microphone - Sony PDW-F335L Operating Instructions Manual

Preparing the Audio Input
System

Using the Supplied Microphone

1
Loosen the screw and open the microphone holder
clamp.
Clamp of the microphone holder
2
Place the microphone in the microphone holder.
Tighten the screw.
Close the microphone holder.
Place the microphone in the holder
so that "UP" is at the top.
3
Plug the microphone cable into the MIC IN connector,
then set the AUDIO IN switch for the channel on
which you want to record the audio from this
microphone to FRONT (for CH-1/CH-2) or F (for CH-
3/CH-4).
Connect to the MIC IN connector.
To use the microphone detached from the
camcorder
You can use the supplied microphone detached from the
camcorder.
Connect to the MIC IN connector.
AUDIO IN (CH-1/CH-2) switches
Set the AUDIO IN switch for the channel on
which you want to record the audio to FRONT
(for CH-1/CH-2) or F (for CH-3/CH-4).
Note
When using the supplied microphone with an extension
cable, always use an external power supply type cable.

Using an External Microphone

You can connect up to two external monaural microphones
to the AUDIO IN CH-1/CH-2 connectors, using a CAC-12
Microphone Holder (not supplied).
The following is the procedure for attaching an electret
condenser microphone such as the ECM-673/674/678.
1
Remove the fixing screws for external microphone
holder.
2
Attach the CAC-12 Microphone Holder.
Screws removed in step 1
CAC-12

Preparing the Audio Input System

43