Specifying An Offset For The Auto White Balance Setting; Setting The Amount Of Compensation For Color Casts By Nd Filters - Sony PDW-F335L Operating Instructions Manual

Item Description
D5600K<A> Sets the color temperature to
approximately 5600K
The above table shows the adjustment of the white
balance of channel A. Items followed by <B> are used
to adjust the white balance of channel B.
3
Turn the MENU knob to select the desired setting, and
press the MENU knob.
4
Repeat steps 2 and 3 until you have set all of the
desired items.
Specifying an Offset for the Auto
White Balance Setting
By setting an offset for the value of auto white balance,
you can make the picture warmer or colder.
(How to select an item in the menu screen: Turn the
MENU knob to move the b mark to the desired item.)
1
Display the OFFSET WHITE page of the
OPERATION menu, and press the MENU knob.
For details on menu operations, see "Basic Menu
Operations" on page 132.
2
Select the desired setting item, and press the MENU
knob.
You can set the following items in the OFFSET
WHITE page.
Item Description
OFFSET WHITE When this item is set to ON, the
<A> offset adjusted on this page is
added to the white balance for
channel A.
WARM-COOL <A> When OFFSET WHITE <A> is
ON, sets the offset for the white
balance of channel A, using the
color temperature. Adjust the
value while looking at the real
image because error tends to be
bigger for adjustment of high color
temperature.
COLOR FINE <A> Adjusts the value more precisely if
the adjustment by WARM-COOL
<A> is not satisfactory.
OFFSET WHITE When this item is set to ON, the
<B> offset adjusted on this page is
added to the white balance for
channel B.
Item Description
WARM-COOL <B> When OFFSET WHITE <B> is
ON, sets the offset for the white
balance of channel B, using the
color temperature. Adjust the
value while looking at the real
image because error tends to be
bigger for adjustment of high color
temperature.
COLOR FINE <B> Adjusts the value more precisely if
the adjustment by WARM-COOL
<B> is not satisfactory.
3
Set the WHITE BAL switch to the channel (A or B)
that you want to set.
Note
If the WHITE BAL switch is not set to A or B, the
adjusted value is not reflected in the video output even
though you carry out the following operation.
4
Turn the MENU knob to perform the settings for each
item, and press the MENU knob.
If you want to set the other channel, go back to step 2.
Setting the Amount of
Compensation for Color Casts by
ND Filters
The internal ND filters are almost color neutral, but there
is a slight color cast for each filter. This can cause the white
balance to shift when you change the position of the
FILTER selector.
The ND COMP function compensates for this
automatically by memorizing a color offset for each filter.
Note that these offset values are adjusted correctly when
the unit is shipped from the factory. Normally you should
not need to carry out the following procedure.
To set the amount of compensation for color
casts
1
Shoot a gray scale or white test card and zoom up so
that it fills the screen.
2
Set the FILTER selector to position 4, and adjust the
lighting so that "OK" appears when the white balance
is adjusted.
3
Display the ND COMP page of the ADVANCED
menu, and then press the MENU knob.
For details on menu operations, see "Basic Menu
Operations" on page 132.
Adjustments and Settings from Menus
143