Table of Contents
Advertisement
Automatic Document Feeder (ADF) Paper Feed Counter
Note:
The ADF Paper Feed Counter is viewed in the Service Mode. It should not be accessed
by end users.
The ADF Paper Feed Counter counts the pages which have been fed by the ADF unit. You may
view the counter and/or reset it. The counter should be reset ONLY when the ADF assembly is
replaced with a different ADF assembly.
Refer to Section 3.2 when installing the ADF assembly ( ).
To access the ADF Paper Feed Counter:
· Verify that the Doc-It 3000/4000 is connected to the Doc-It controller.
· Verify that the Doc-It 3000/4000 is initialized.
· Press and hold the
· Release the
ENTER
·
ADMINISTRATION
· Open the scanner cover.
· While pressing the
key.
· The word Service will be displayed on the LCD.
· Move through the adjustments by pressing the down or up arrow keys until the LCD
displays
· Check marks indicate the current setting.
· If replacing the ADF assembly, press the right arrow key until the check mark appears
next to the word Yes.
· Press the
ENTER
· Press the
STOP
administration menu.
· Exit the Administration Mode by pressing any of the four mode keys (Printer, FAX,
Scanner, or Copier).
Copyright 1997, Okidata, Division of OKI America, Inc. All rights reserved. See the OKIDATA Business
Partner Exchange (BPX) for any updates to this material. (http://bpx.okidata.com)
Service Guide DOC-IT3000/4000
ENTER
key for five seconds.
key.
will be displayed on the LCD.
START
button of the scanner unit, press and release the
ADF ctr (VALUE) Reset?
No
Yes
key.
key twice to exit the service menu. This will return you to the
Chapter 3 Maintenance & Disassembly
Page: 174
ENTER
Advertisement
Table of Contents
