2 - 3
Paper feed jam
•
Does a paper feed jam occur when the power is turned on?
•
Yes
Is the paper on the paper sensor lever?
• Yes
•
No
Does the paper sensor lever operate smoothly?
• No
•
Yes
Clean the paper sensor. (See Fig. 2-3 Sensor Layout Diagram.)
•
Is the printer recovered?
• No
•
YES END.
•
No
Has the paper reached the paper sensor lever?
•
No
Is the registration motor rotating?
• No
• No
• Yes
• Yes
• Is the printer recovered?
• YES END.
Go to on the next page
Go to on the next page
Troubleshooting
Remove the paper.
Replace the paper sensor lever.
Replace the Power/sensor board.
Is there any defective gear in the motor bracket assembly.
•
Yes
Replace the defective gear.
Are the connections for CN3 connector on the Power/sensor board,
between CN8 and CN7 connectors on the Control board and registra-
tion motor, and for POWER connector and FRONT connector (white
9-pin or 7-pin connector) made properly.
•
No
Connect these connectors properly. If a defective cable is
found, replace the defective cable.
Is the coil resistance (normal resistance: 6.7 Ω) of the registration
motor normal?
•
No
Replace the registration motor
Replace the Driver board.
•
No
Replace the Main board.
.
A
B
.
6 - 22
OKIPAGE 16n
Service Manual, P/N 59274401