%2-3 Paper feed jam
2-3
Paper feed jam
Does a paper feed jam occur when the power is turned on?
Yes
Is the paper on the paper sensor lever?
t
No
Does the paper sensor lever operate smoothly?
t
Yes
Clean the paper sensor. (See Fig. 2-3 Sensor Layout Diagram.)
t
Is the printer recovered?
t
YES END.
No
Has the paper reached the paper sensor lever?
No
Is the registration motor rotating?
t
t
t
t
t
t
Go to on the next flow .
t
Go to on the next flow.
Yes
Remove the paper.
No
Replace the paper sensor lever.
No
Replace the Power/sensor board.
No
Is there any defective gear in the motor bracket assembly.
Yes
Replace the defective gear.
No
Are the connections for CN3 connector on the Power/sensor board,
between CN8 and CN7 connectors on the Control board and
registration motor, and for POWER connector and FRONT connector
(white 9-pin or 7-pin connector) made properly.
No
Connect these connectors properly. If a defective cable is
found, replace the defective cable.
Yes
Is the coil resistance (normal resistance: 6.7 W) of the registration
motor normal?
No
Replace the registration motor
Yes
Replace the Driver board.
Is the printer recovered?
No
Replace the Control board.
YES END.