Advice for the installer
The appliance is designed and approved for domestic use only and should not be
installed in a commercial, semi commercial or communal environment.
The appliance may be installed in a kitchen, Kitchen/diner or a bed sitting room, but
not in a room or space containing a bath or a shower.
The appliance must not be installed in a bed-sitting room of less than 20 m
Your product will not be guaranteed if installed in any of the above environments
and could affect any third party or public liability insurances you may have.
Cooker installation must only be carried out by a SUITABLY QUALIFIED AND
REGISTERED TECHNICIAN and in compliance with local safety standards.
Failure to observe this rule will invalidate the warranty.
The appliance must be installed in compliance with regulations in force in your country
and in observation of the manufacturer's instructions.
Always disconnect the appliance from the power supply before carrying out any
maintenance operations or repairs.
The walls surrounding the appliance must be made of heat-resistant material.
Take care NOT to lift the oven by the door handle/s.
Some appliances are supplied with a protective film on steel and aluminium parts.
This film must be removed before using the cooker.
Important: The use of suitable protective clothing/gloves is recommended when
handling or installing of this appliance.
your product meets all safety
requirements laid down for this
type of product category.
However special care should
be taken around the rear or the
underneath of the appliance as
these areas are not designed
orintended to be touched and
may contain sharp or rough
edges, that may cause injury.
USABLE lit = 100