Table of Contents
Advertisement
10 - ELECTRICAL INSTALLATION
IMPORTANT: The cooker must be installed in accordance with the manufacturer's
instructions. Incorrect installation, for which the manufacturer accepts no
responsibility, may cause damage to persons, animals and things.
The connection of the appliance to earth is mandatory. The manufacturer declines
all responsability for any inconvenience resulting from the inobservance of this
condition.
Before effecting any intervention on the electrical parts of the appliance, the
connection to the network must be interrupted.
FOR YOUR SAFETY PLEASE READ THE FOLLOWING INFORMATION:
This appliance must be installed by a qualified technician according with the current local
regulations and in compliance with the manufacturer instructions.
This appliance is supplied with a moulded 13 amp three pin mains plug with a 3 amp fuse
fitted. Should the fuse require replacement, it must be replaced with a fuse rated at 3 amp
and approved by ASTA or BSI to BS 1362.
The plug contains a removable fuse cover that must be refitted when the fuse is replaced.
In the event of the fuse cover being lost or damaged, the plug must not be used until a
replacement cover has been obtained. Replacement fuse covers can be purchased from
your nearest electrical dealer and must be the sarne colour as the original.
IF THE MOULDED MAINS PLUG IS UNSUITABLE FOR THE SOCKET OUTLET IN YOUR
HOME OR IS REMOVED FOR ANY OTHER REASON, THEN THE FUSE SHOULD BE
REMOVED AND THE CUT OFF PLUG DISPOSED OF SAFELY TO PREVENT THE
HAZARD OF ELECTRIC SHOCK.
THERE IS A DANGER OF ELECTRICAL SHOCK IF THE CUT OFF PLUG IS INSERTED
INTO ANY 13 AMP SOCKET OUTLET.
If a replacement plug is to be fitted, please observe the wiring code shown below.
Warning! This appliance must be earthed.
A properly earthed three pin plug (fused at 3 amps, to BS 1362 ASTA approved) must be
used. As the colours of the wires in the mains lead of this appliance may not correspond
with the coloured markings identifying the terminals in your plug, proceed as follows:
•
The wire which is coloured GREEN &
YELLOW must be connected to the
terminal in the plug which is marked
with letter "E" or by the Earth symbol "
" or coloured GREEN & YELLOW.
•
The wire which is coloured BLUE must
be connected to the terminal which is
marked with the letter "N" or coloured
BLACK.
•
The wire which is coloured BROWN
must be connected to the terminal
which is marked with the letter "L" or
coloured RED.
Green & Yellow
Earth
Blue Neutral
3 amp fuse
Brown Live
Fig. 10.1
41
Hide quick links:
Advertisement
Table of Contents
