Volvo VNL Service Manual page 96

Group 30 Electrical System—VNL, VNM
13
Install the left side drip molding with 3
screws. Torque the top 2 screws to
1.2 ± 0.2 Nm (10.5 ± 2 in-lb) , and the
bottom to 3 Nm ± 0.5 (26 ± 5 in-lb).
14
Install 3 bolts in the lower left side mir-
ror arm. Torque to 24 ± 4 Nm (18 ± 3
ft-lb).
15
Install the right side quarter fender
section. START bolts, but do not
tighten until after aligning. Torque to
24 ± 4 Nm (18 ± 3 ft-lb).
94
16
Install the tank fairing. START all
bolts, then tighten after aligning fairing.
Torque to 24 ± 4 Nm (18 ± 3 ft-lb).
W3000664
1.2 ± 0.2 Nm
(10.5 ± 2 in-lb)
17
3 Nm ± 0.5
(26 ± 5 in-lb)
24 ± 4 Nm
(18 ± 3 ft-lb)
Install the step. START all 4 bolts,
then tighten after aligning the step.
W3000661
24 ± 4 Nm
Torque to 12 ± 1 Nm (105 ± 9 in-lb).
(18 ± 3 ft-lb)
Service Procedures
W3000662
24 ± 4 Nm
(18 ± 3 ft-lb)
W3000667
12 ± 1 Nm
(105 ± 9 in-lb)