Volvo VNL Service Manual page 75

Group 30 Electrical System—VNL, VNM
5
When the tools are inserted, pull
slightly apart to unlock the radio from
the housing. Pull on the removal tools
to slide the radio out of the housing.
Disconnect the antenna and electrical
connector.
Installation
1
Make certain the vehicle ignition is
OFF before beginning this procedure.
2
Connect radio electrical connector and
antenna.
3
1 Lower edge of dash
2 Nut at radio mounting bracket
W3000674
Slide the radio into the housing, mak-
ing sure the stud on the rear of the
radio is aligned with the mounting
bracket. Install the nut into the bracket
to hold the radio in position. Torque to
1.2–1.6 Nm (10–14 in-lb).
Note: When sliding the radio into posi-
tion, make certain the antenna cable
and electrical connection do not get
between the radio and radio bracket.
4
Install the lower dash trim panel with 8
torx bolts. Torque to 3.5 ± 0.5 Nm (31
± 4.5 in-lb).
Service Procedures
W3000675
1.2–1.6 Nm
(10–14 in-lb)
3.5 ± 0.5 Nm
(31 ± 4.5 in-lb)
73