Table of Contents
Advertisement
Group 30 Electrical System—VNL, VNM
6
Removing Fog/Driving Light Switch from Panel
Disconnect connector of switch being
removed. Remove switch from panel
by inserting a No. 1 screwdriver into
the back of the switch at the top and
bottom to release the locking tabs.
7
Note: The light switch is removed
through the front of the panel.
Installation
1
W3000679
Install new fog/driving lamp switch into
panel. Push the switch into the panel
until it locks. Push back on the switch
to make certain it is locked in the
panel. Connect electrical connector.
2
W3000682
Install the panel by inserting tips on
right side and pushing the panel into
position. The clips will snap in place
on the left side.
Service Procedures
W3000680
W3000647
63
Hide quick links:
Advertisement
Table of Contents
