Volvo VNL Service Manual page 83

Group 30 Electrical System—VNL, VNM
5
1) Spacers
Remove 3 bolts from the fuse panel,
and fold the fuse panel outward from
the dash to gain access to the mount-
ing bolts for the top TEC tray.
Removing the lower bolts is made
easier by inserting the torx driver
through the ashtray opening.
Note: Do not lose the 2 plastic spac-
ers on the back of the fuse panel.
6
Remove the top TEC tray by removing
2 torx bolts at the front of the tray, and
loosening 2 nuts at the rear.
7
Disconnect the module connector, re-
move mounting screws from the
module, and remove the module.
Installation
1
Install the module in the same location
where the old module was installed.
Bolt the module in place with 2 torx
bolts. Torque to 4.5 ± 0.5 Nm (40 ± 5
in-lb). Connect the module electrical
connector.
2
Install the top TEC tray by sliding the
tray's rear slots back onto the nuts.
Start the bolts in the tray at the front
before tightening. Torque rear nuts to
6 ± 1 Nm (53 ± 1 in-lb). Torque front
bolts to 10 ± 1.5 Nm (89 in-lb).
W3001007
3
Install the fuse panel with 3 torx bolts,
reaching through the ashtray opening
to install the lower bolt. Torque to 4.5
± 0.5 Nm (40 ± 5 in-lb). Align the 2
plastic spacers with the bolts, taking
care to route the wires so that none
are caught between the spacers and
mounting brackets, or between the
spacers and fuse panel.
4
Install the ashtray housing and ash-
tray. Torque ashtray mounting screws
to 0.4 ± 0.1 Nm (3.5 ± 1 in-lb).
5
W3000998
Install the fuse panel cover and the
top TEC panel cover. Torque screws
to 2.5 ± 0.5 Nm (22 ± 5 in-lb).
1) Spacers
Service Procedures
4.5 ± 0.5 Nm
(40 ± 5 in-lb)
6 ± 1 Nm
(53 ± 1 in-lb)
10 ± 1.5 Nm
(89 in-lb)
W3001007
4.5 ± 0.5 Nm
(40 ± 5 in-lb)
0.4 ± 0.1 Nm
(3.5 ± 1 in-lb)
2.5 ± 0.5 Nm
(22 ± 5 in-lb)
81