Assembly Instructions - Hotsy 781SS Operating Instructions And Parts Manual

unpacking
Unpack carefully. Wear safety glasses or goggles while
unpacking, assembling, or operating pressure washer.
If there are missing components or hidden damage,
immediately contact carrier concerning discrepancies.
1. Cut strapping band from pressure washer and pal-
let.
2. Remove pressure washer from pallet.
parts included
• Pressure Washer
• Pressure Hose
• Wand
• Operating Instructions and Parts Manual
• Gasoline Engine Manual
• Parts Bag Containing:
Pressure Nozzles (3 Ea.)

Quick Disconnects (2 Ea.)

 Quick Disconnect Plug
Trigger Gun

tools required
• 8" Adjustable Wrench
• Teflon Tape
• Flat Blade Screwdriver
pressure hose, trigger gun and Wand
1. When assembling, use teflon tape on all threaded
plumbing connections to prevent leakage.
2. Install the pressure hose on the pressure washer as
shown in figure 1.
coil Outlet
pressure hose
Figure 1 - Pressure Hose Installation

aSSEMbLy inStructiOnS

rupture Disk
97-6642 • HOTSY 781SS, 871SS, 921SS • REV. 7/06
3. Assemble wand components as shown in figure 2.
Wand
quick
Disconnect
quick Disconnect plug
Figure 2 - Wand Component Installation
NOTE: The pressure nozzle is not to be installed at
this time.
4. Make sure all plumbing connections are tight.
quick
Disconnect
trigger
gun
pressure
hose
7