Sub-Zero Integrated Refrigeration Installation Manual page 9

Site Preparation
Anti-Tip Bracket Installation
To prevent the unit from tipping forward and provide
a stable installation, the unit must be secured in place
with the anti-tip brackets shipped with the unit.
An anti-tip bracket and hardware is provided with the inte-
grated unit. Placement of the anti-tip bracket is critical to
a stable installation. The anti-tip bracket must be installed
on a solid base.
If you are installing the unit in a space deeper than 24"
(610), be sure to locate the anti-tip bracket so that it
engages the unit properly. It is important that the anti-tip
bracket is placed 24" (610) from the front of the unit
(without panels) to the back of the anti-tip bracket.
IMPORTANT NOTE: In some installations the subflooring
or finished floor may require angling the wood screws
used to fasten the anti-tip bracket to the back wall. Refer
to the illustrations.
Make sure there are no electrical wires or plumbing
in the area which the screws could penetrate.
WOOD FLOOR APPLICATIONS
1
Use the six #12 x 2 / " wood screws and the six
2
washers provided. Drill pilot holes
maximum, and be sure that the screws penetrate through
the flooring material and into the wall plate a minimum of
3
/ " (19). Be sure that the screws hold tight. Refer to the
4
illustration below.
CONCRETE FLOOR APPLICATIONS
3 3
Use the two / " x 3 / " concrete wedge anchors, two
8 4
1
#12 x 2 / " wood screws and two
2
provided. Be sure that the anchors and screws hold tight.
Refer to the illustration below.
Anti-Tip Bracket Placement
27" Models
(686)
36" Models
(914)
FINISHED FLOORING
UNDERLAYMENT
WALL PLATE
SUBFLOORING
CONCRETE
FLOOR
Wood floors.
subzero.com
1
/ " flat
4
3
/ " (5) diameter
16
1
/ " flat washers
4
1
13 / "
(343)
2
18"
(457)
FINISHED FLOORING
UNDERLAYMENT
WALL PLATE
SUBFLOORING
1 1 / "
2
min CONCRETE
( 38 )
FLOOR
Concrete floors.
9
A