Integrated Refrigeration - Sub-Zero Integrated Refrigeration Installation Manual

Integrated Refrigeration

Sub-Zero Integrated Refrigeration
The importance of the installation of the Sub-Zero
integrated unit cannot be overemphasized. Installation
should be done by a qualified installer.
Before you begin the installation process, it is recom-
mended that you read this entire installation guide. There
are key details that you should take special care to
observe during the installation. By reading these instruc-
tions carefully, you will make the installation process
easier, problem-free and, most importantly, safe.
Any questions or problems regarding the installation
should be directed to your Sub-Zero dealer or Sub-Zero
customer service at 800-222-7820. You may also check
the contact & support section of our website, subzero.com.
Important product information, including the model and
serial number of your unit are listed on the product rating
plate. The rating plate is located inside the cabinet, to the
left of the upper drawer. Refer to the illustration below.
IMPORTANT NOTE: Throughout this guide, dimensions in
parentheses are millimeters unless otherwise specified.
RATING PLATE
Location of rating plate.
Before You Start
Make sure that the finished rough opening where the
integrated unit is to be installed is properly prepared.
Refer to the specifications for your specific model on the
following pages. Make sure that the opening dimensions,
door and drawer clearances, electrical service and
plumbing are correct for the model you are about to
install.
IMPORTANT NOTE: The inside edges of the rough
opening, as well as the sides and a portion of the
backside of the decorative panels will need to be finished,
as they will be exposed when the doors are open.
TOOLS AND MATERIALS REQUIRED
• Appliance dolly able to support 500 lbs (227 kg) and
adequate manpower to handle the weight of the unit.
• Phillips and slotted screwdrivers.
• Allen, standard and crescent wrenches.
• Various sized pliers.
5
• / " hex bolt nut driver.
16
• Cordless drill and assorted drill bits.
• Level—2' (.6 m) and 4' (1.2 m) recommended.
1
• 4' (1.2 m) of / " copper tubing and saddle valve for the
4
water line (4200880)—do not use self-piercing valves.
• Copper tubing cutter.
1
• Masonite, plywood,
or other suitable material to protect finished flooring.
• Appropriate materials to cover and protect the home
and its furnishings during installation.
subzero.com
/ " pressed fiberboard, cardboard
8
3