Sub-Zero Integrated Refrigeration Installation Manual page 12

Integrated Installation
Level the Unit
Level the integrated unit by turning the front leveling legs
clockwise to raise the unit, or counterclockwise to lower it.
To assist you in adjusting the front leveling legs up or
down, use a standard screwdriver blade and place it in the
front leveling leg as shown in the illustration below.
The rear leveling legs are adjusted from the front of the
base by turning the Phillips head screw as shown in the
illustration below.
IMPORTANT NOTE: The rear leveling legs will only move
1
/ " (2) for every 18 revolutions on the Phillips head
16
screw. Do not over torque. Use the lowest torque setting
on any power screwdriver. Do not turn the rear leveling
legs by hand. Damage will occur if you turn these legs.
Once the unit is leveled, secure the unit in place by using
the side mounting clips and #8 x
To reduce the possibility of the unit tipping forward,
the front leveling legs must be in contact with the
floor.
Front leveling legs.
1
/ " screws provided.
2
Rear leveling legs.
Molding Installation
The decorative white molding strips for the side and top of
the unit can be snapped into place. The top molding strip
used on integrated tall units, must be installed before the
side molding can be attached. The top molding strip is
held in place by double-sided velcro fasteners. Refer to
the illustration below for positioning of the top molding.
The illustration below shows side molding installation for
tall units. Installation of the side molding for base units is
the same. For installations where units are side by side,
refer to dual installations on page 18.
The molding strips may be painted to match surrounding
cabinetry, if desired. Follow these easy steps:
• Rough up the surface to be painted with fine grit
sandpaper.
• Wipe with alcohol to ensure that the surface is clean
and dry.
• Use an appliance or industrial grade, oil base, high
gloss enamel paint.
TOP
MOLDING
Top molding.
SIDE
MOLDING
Side molding.
12