Sub-Zero Integrated Refrigeration Installation Manual page 17

Integrated Installation
Panel Installation
DRAWER PANEL INSTALLATION
Remove the mounting hardware provided and set aside.
As with the door panel, you should work on the back side
of each drawer panel to protect the front surface.
Position the top edge of the template (provided) flush with
the top edge of each drawer. For the top drawer, there is
only one location for the lower mounting bracket. The
bottom drawer allows a second option by inverting the
lower mounting bracket, depending on the height and
thickness of the panel. Refer to the illustration below.
Secure the template in place and mark the pilot holes.
Remove the template and drill pilot holes for mounting the
bracket. Place the mounting brackets in the proper
location with the tabbed bracket on top and 'L' bracket on
the bottom of the panel. Fasten brackets securely with the
1
#8 x / " screws provided. Refer to the illustration below.
2
To help with the placement of the drawer panels, examine
the lower 'L' bracket and panel to determine the slotted
holes on the bracket that will be used. Then position
screws into the lower portion of the drawer that corre-
spond with these slots. Leave the screws out slightly so
the slotted holes will slide under the heads.
TEMPLATE FLUSH WITH
TOP OF PANEL
SIDE
EDGE GAP
WILL VARY
BACK OF PANEL
Template position—drawer.
TABBED BRACKET
L BRACKET
Drawer panel installation.
With the two mounting brackets in place, install the
drawer panel by engaging the top tabbed bracket first,
then slide the lower 'L' bracket onto the positioning
screws. Each drawer panel can be adjusted
down and side to side. Fasten all screws to the lower 'L'
bracket to secure the drawer panel.
Drawers can be placed back in the unit. Reconnect the
control cable for the top drawer (drawer units only). Refer
to the illustration below.
Control cable—drawer unit.
17
subzero.com
1
/ " (6) up and
4