Sub-Zero Integrated Refrigeration Installation Manual page 13

Integrated Installation
Water Line Connection
QUICK CONNECT WATER VALVE
For units with an ice maker, the quick connect water valve
and PEX tubing are located on the bottom right side of the
unit.
To connect the ice maker water line, attach the union
fitting to the copper house water supply line. Pull the
coiled gray PEX tubing with red cap and captured nut
toward the house water supply line. Remove and discard
the red cap. Then attach the tubing to the union with the
nut. Tighten all connections. Recoil the excess tubing
under the unit. Refer to the illustration below.
Turn on the water supply and check all fittings for leaks.
Make certain the electrical harness is attached to the
solenoid.
In areas with water of high mineral content, an in-line
water filter is recommended. Make sure the filter is acces-
sible for replacement when necessary.
The ice maker will not fill with water immediately. Allow 24
hours for proper ice production. The first container of ice
should be discarded. As with any new connection, there
may be impurities in the ice from the water supply line.
PEX
TUBING
Top anchoring.
Shut power off at the circuit breaker before making
electrical connection to the solenoid.
13
subzero.com