•
On the General tab, set Outgoing packet protocol to RIP version 2 broadcast, and
Incoming packet protocol to RIP version 1 and 2.
5.8.2 Routing Screen
The routing table is accessed by the Routing link on the Administration menu.
Using this Screen
Generally, you will use either RIP (Routing Information Protocol) OR the Static Routing Table,
as explained above, although is it possible to use both methods simultaneously.
Static Routing Table
•
If RIP is not used, an entry in the routing table is required for each LAN segment on your
Network, other than the segment to which this device is attached.
•
The other Routers must also be configured. See 5.8.3 Configuring Other Routers on your
LAN later in this chapter for further details and an example.
Data - Routing Screen
RIP
Enable RIP
Figure 29: Routing Screen
Check this to enable the RIP (Routing Information Protocol) feature
of the BLW-54PM. The BLW-54PM supports RIP 1 only.
55