Wireless Screen - Planex BLW-54PM User Manual

Using the BLW-54PM' s DHCP Server
This is the default setting. The DHCP Server settings are on the LAN screen. On this screen,
you can:
•
Enable or Disable the BLW-54PM's DHCP Server function.
•
Set the range of IP Addresses allocated to PCs by the DHCP Server function.
Note:
You can assign Fixed IP Addresses to some devices while using DHCP, provided that the Fixed
IP Addresses are NOT within the range used by the DHCP Server.
Using another DHCP Server
You can only use one (1) DHCP Server per LAN segment. If you wish to use another DHCP
Server, rather than the BLW-54PM's, the following procedure is required.
1. Disable the DHCP Server feature in the BLW-54PM. This setting is on the LAN screen.
2. Configure the DHCP Server to provide the BLW-54PM's IP Address as the Default
Gateway.

3.5 Wireless Screen

The BLW-54PM's settings must match the other Wireless stations.
Note that the BLW-54PM will automatically accept both 802.11b and 802.11g connections,
and no configuration is required for this feature.
To change the BLW-54PM's default settings for the Wireless Access Point feature, use the
Wireless link on the main menu to reach the Wireless screen. An example screen is shown
below.
18